| Applies To | |||
| Product(s): | AutoPIPE, | ||
| Version(s): | 2004, XM, & V8i | ||
| Environment: | Enhancements | ||
| Area: | |||
| Subarea: | |||
| Original Author: | Bentley Technical Support Group | ||
The following Dynamic Analysis enhancements have been logged for inclusion into a future version of AutoPIPE:
Note: if an enhancement has not been added to the program, log an Service request for that enhancement. The more requests logged per an enhancement, the quicker the CAE development team will add that feature to the program.
TFS-E251038:
Time History Post Processor: Add feature for user to specify length of time >1sec
Description:
For time history post processing plots, add feature to enable user to specify x-axis limit > 1 sec.
Corrected Version: TBD
TFS-E139516:
Add feature to apply 15% Peak Spectrum Broadening for dynamic analysis per NRC Guide 1.122.
Corrected Version : TBD
TFS-E137935:
Increase maximum defined harmonic load cases
Corrected Version : TBD
CAE-CR-10998:
Program should block dynamic analysis if static analysis set #1 not analyzed
Description:
Program should block dynamic analysis if first analysis set not analyzed. There is an internal limitation of the program that the first static analysis set should always be selected for analysis if there is any dynamic analysis to be performed for the model. AutoPIPE historically had only 1 load set prior to 9.1.0, all of the definitions related to dynamic load cases etc used to be associated with this single load set. In the new system – this older load set is mapped to the first static analysis set.
Corrected Version: 9.6.0.10
CAE-CR-4560:
Add the ability to import time history load file from Bentley HAMMER.
Corrected Version: TBD
See Also
External Links
Bentley Technical Support KnowledgeBase
Comments or Corrections?
Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article to
the "Comments" area below. THANK YOU!
